Method of the Environmentally Friendly Dry Single-Pass Honing with Use of the Superimposed Low Frequency Oscillations

Single-pass honing is used as a finishing process to meet high demands regarding form and dimensional accuracy of drilled holes. The disadvantages of single-pass honing compared to the conventional long-stroke honing are high process forces and torques as well as an increased risk of chip space clogging of the abrasive stones. Following this, the oscillation-superimposed single-pass honing without cutting fluid has been conducted in this work, which is promising when it comes to the environmentally friendly improvement of machining processes. It was shown that the omitted lubrication and flushing effect of the contact zone between the tool and the workpiece could be compensated with the aid of the superimposed oscillations. The process forces of the dry honing process are up to 37% lower compared to the conventional process, the height of the surface profile Rz decreases by 33% and the form deviations decrease up to 47%. Hence, the new method allows the saving of resources, while improving the work results.