Options
December 1, 2024
Master Thesis
Title
Boron-assisted Direct Regeneration of Cathode Active Materials in Recycling spent lithium-ion batteries
Abstract
This work presents a novel and unique recycling strategy for the direct recycling of cathode active materials in lithium-ion batteries, which combines mechanochemistry and successive heat treatment with the aid of boron in form of boric acid. The developed process was utilized on various cathode chemistries, including pristine LiCoO2, two blackmass series, NCA and NCM 622, as well as scrap material NCM 433. Structural and chemical investigations of the starting and recycled material included XRD, SEM-EDX, ICP-OES and electrochemical cell test.
The results reveal that milling and heat treatment had a substantial influence on material properties. Heat treatment increased crystallinity and promoted the development of bigger secondary particles, whereas milling caused structural disorder and microstrain. By combining both, milling and heat treatment, the
structural disorder and strain after milling could not be alleviated completely and therefore emphasizes the need for optimizing the individual process steps further.
The incorporation of boron of up to 1% increased electrochemical performance, notably for LCO and scrap NCM 433, without altering the layered structure significantly. However, boron concentrations more than 1% favored the formation of undesirable secondary phases in both materials, impairing the electrochemical performance of these materials. The two blackmass series did not result in any improved electrochemical performance, which could be the result of high impurity levels and structural degradation of the blackmass either during the use or due to the EHZ process during pretreatment that utilizes water as medium. This emphasizes that more care needs to be taken on removing the impurities in the obtained cathode materials of pretreatment processes and simultaneously keeping the structure intact, which is detrimental for the direct recycling process. Nonetheless, the process applied in this study demonstrates promising results of the recovery of cathode active materials and delivers valuable insights into the optimization of the process and highlights the beneficial use of boron into the direct recycling scheme.
The results reveal that milling and heat treatment had a substantial influence on material properties. Heat treatment increased crystallinity and promoted the development of bigger secondary particles, whereas milling caused structural disorder and microstrain. By combining both, milling and heat treatment, the
structural disorder and strain after milling could not be alleviated completely and therefore emphasizes the need for optimizing the individual process steps further.
The incorporation of boron of up to 1% increased electrochemical performance, notably for LCO and scrap NCM 433, without altering the layered structure significantly. However, boron concentrations more than 1% favored the formation of undesirable secondary phases in both materials, impairing the electrochemical performance of these materials. The two blackmass series did not result in any improved electrochemical performance, which could be the result of high impurity levels and structural degradation of the blackmass either during the use or due to the EHZ process during pretreatment that utilizes water as medium. This emphasizes that more care needs to be taken on removing the impurities in the obtained cathode materials of pretreatment processes and simultaneously keeping the structure intact, which is detrimental for the direct recycling process. Nonetheless, the process applied in this study demonstrates promising results of the recovery of cathode active materials and delivers valuable insights into the optimization of the process and highlights the beneficial use of boron into the direct recycling scheme.
Thesis Note
Darmstadt, Hochschule, Master Thesis, 2024
Open Access
File(s)
Rights
CC BY 4.0: Creative Commons Attribution
Language
English