Now showing 1 - 2 of 2
  • Publication
    Residual stress assessment during cutting tool lifetime of CVD-diamond coated indexable inserts
    ( 2022)
    Uhlmann, E.
    ;
    Hinzmann, Daniel
    Insufficient coating adhesion limits reproducibility regarding tool lifetime as well as workpiece quality during the application of CVD-diamond coated cutting tools. Depending on the combination of tungsten carbide substrate material, coating thickness as well as coating morphology, individual residual stress conditions exist within CVD-diamond coated cutting tool specifications. The application of these tools is accompanied by coating delamination as primary cutting tool failure. The tool lifetime of the respective cutting tool composition depends on the corresponding residual stress condition until crack development within the CVD-diamond coating initiates tool failure. During external cylindrical turning of hypereutectic aluminium silicon alloy AlSi17Cu4Mg-T6 the residual stress condition of a CVD-diamond coated cutting tool is assessed along the cutting edge, the rake face as well as flank face throughout the respective tool lifetime. Consequently, the progression of the residual stress condition until cutting tool failure regarding coating delamination is observed. During the tool lifetime of the investigated CVD-diamond cutting tools, compressive residual stress ∆σR,c shifts to tensile residual stress ∆σR,t underneath the cutting edge corner. The approximated residual stress difference of ∆σR ≈ 5 GPa indicates stress peak relaxation processes, such as crack initiation, within the CVD-diamond coating.
  • Publication
    Micro-texture dependent temperature distribution of CVD diamond thick film cutting tools during turning of Ti-6Al-4V
    ( 2022) ;
    Schröter, D.
    ;
    Machining titanium alloys such as Ti-6Al-4V results in a high thermomechanical load on cutting tools and consequently short tool lifes. With respect to a necessary reduction of the resulting cutting tool temperatures, ultrashort pulse (USP) laser fabricated micro-textured rake faces offer direct supply of cooling lubricant into the cutting zone and lead to a reduced heat induction. As a result, micro-textured CVD diamond thick film cutting tools are also capable of machining high-performance materials due to reduced contact temperatures. In the scope of the research, the resulting temperature distribution for micro-textured rake faces will be compared under both dry and wet process conditions. Measurements show a reduction of the resulting cutting tool temperatures of Δϑt = 27.9 % using micro-textured cutting tools compared to non-textured cutting tools. A validated simulation provides valuable information about the contact temperatures enabling a specific development of the micro-texture geometry. As a result, a reduction of the contact temperature between chip and rake face by ΔϑT = 24.7 % was possible.