Fraunhofer-Gesellschaft

Publica

Hier finden Sie wissenschaftliche Publikationen aus den Fraunhofer-Instituten.

Mikrostrukturelle Charakterisierung der von kurzen Lichtpulsen hoher Intensität hervorgerufenen Werkstoffveränderungen. Abschlußbericht

Forscherverbund: Grundlagen der präzisen, optischen Behandlung von Festkörpern (PROBE). Teilvorhaben
 
: Franz, U.; Luft, A.; Kaspar, J.; Emsermann, A.
: Fraunhofer-Institut für Werkstoff- und Strahltechnik -IWS-, Dresden; Volltext (15.4 M, PDF)

:
Volltext urn:nbn:de:0011-px-530256 (15.8 MByte PDF)
MD5 Fingerprint: 205c6d8be5fa62fea5ef3fd977ed12c4
Erstellt am: 22.10.1998


Dresden: IWS, 1998, 105 S. : Ill.
Reportnr.: BMBF 13N6154
Deutsch
Bericht, Elektronische Publikation
Fraunhofer IWS ()
electron microscopy; laser drilling; microstructure

Abstract
The report given focuses on a comparative study of laser-drilled micro holes which were produced in metals, silicon and fused silica using different short-pulse lasers (copper vapour laser, Nd:YAG laser, Nd:YLF-laser, Ti:sapphire laser) under a wide range of processing parameters (pulse widths: 50 ns to 100 fs, fluencies 10 J/cm2 to 1000 J/cm2, peak power densities 108 W/cm2 to 1015 W/cm2, pulse repetition rates 10 Hz to 7 kHz). Typically, the laser-drilled holes were 0,1 mm to 1 mm deep with entrance d e production of percussion-drilled holes with a high rate of material ablation (about 1 5m per pulse) does not lead to any appreciable reduction in the melt component, material re-deposition or thermal load on the wall of the hole. Using small pulse energies it is possible to reduce the mechanical loads on the material due to the laser-induced pressure in the drill channel whereas the formation of heat affected zones and of thermal stresses due to cooling down of heat affected zones can be reduced.

: http://publica.fraunhofer.de/dokumente/PX-53025.html