Hier finden Sie wissenschaftliche Publikationen aus den Fraunhofer-Instituten.

Cutting forces while machining STAVAX ESU with binderless-cBN

: Uhlmann, E.; Oberschmidt, D.; Polte, J.; Polte, M.

Volltext (PDF; )

European Society for Precision Engineering and Nanotechnology -EUSPEN-:
17th International Conference & Exhibition of the European Society for Precision Engineering and Nanotechnology, EUSPEN 2017 : 29th May – 2nd June 2017, Hannover, Germany
Bedford: Euspen, 2017
ISBN: 978-0-9957751-0-7
European Society for Precision Engineering and Nanotechnology (EUSPEN International Conference & Exhibition) <17, 2017, Hannover>
Konferenzbeitrag, Elektronische Publikation
Fraunhofer IPK ()

Binderless-cubic-Boron-Nitride(cBN) from the company SUMITOMO CORPORATION, Itami, Japan, provides the opportunity for direct cutting of steel with ultra-precision quality without additional equipment or coating of the workpiece. This work presents the latest results in the field of ultra-precision machining of hardened stainless steel with binderless-cBN. In this paper the influence of the cutting speed vc, the feed f, the depth of cut ap, and the cooling lubricant on the cutting force Fc is shown for turning the stainless steel STAVAX ESU. The cutting speed, the feed and the depth of cut were varied between 3 m/min ≤ vc ≤ 450 m/min, 0.9 μm ≤ f ≤ 9.7 μm, and 5 μm ≤ ap ≤ 30 μm respectively. As cooling lubricants compressed air and W200SL of the company OPORTET, Duisburg, Germany, with a volumetric flow rate ̇ = 1 l/min were used. For measuring the cutting forces Fc the piezoelectric dynamometer MINIDYN 9256C2 from the KISTLER INSTRUMENTE AG, Middlefield, USA, was used. As a result of this work cutting forces Fc ≤ 4.9 N could be observed with an inconstant progression over the varied process parameters.