Hier finden Sie wissenschaftliche Publikationen aus den Fraunhofer-Instituten.

Electrical properties of aerosol printed contacts

: Filipovic, A.; Binder, S.; Hörteis, M.; Schmidt, D.; Merkel, J.J.; Glunz, S.W.

Volltext urn:nbn:de:0011-n-2095265 (343 KByte PDF)
MD5 Fingerprint: a6dfa6afca753f7dd5d73fae90b51ffa
Erstellt am: 15.8.2012

Sinke, W. ; WIP - Renewable Energies, München; European Commission; UNESCO; World Council for Renewable Energy; International Photovoltaic Equipment Association:
24th European Photovoltaic Solar Energy Conference 2009. CD-ROM : The compiled State-of-the-Art of PV Solar Technology and Deployment. Proceedings of the International Conference held in Hamburg, 21-25 September 2009
München, 2009
ISBN: 3-936338-25-6
European Photovoltaic Solar Energy Conference and Exhibition (EU PVSEC) <24, 2009, Hamburg>
Konferenzbeitrag, Elektronische Publikation
Fraunhofer ISE ()

The influence of printing height of the seed layer on the front side metallization was investigated. Therefore, solar cells were metalized using the aerosol printing technique and the seed layer ink for the metallization of solar cells (SISC) developed at Fraunhofer ISE. The single lines were deposited one over each other increasing the amount of ink per contact area. After contact firing and light-induced plating, the contact resistance was determined using the transfer-length model (TLM). The finger geometry was determined from cross sectional measurements and the conductivity from 4-probe measurements. In order to analyse the relationship between the amount of printed ink and the contact quality, the metal contacts were removed in an HNO3/HF etching step and the metal semiconductor interface was analyzed via SEM images. It could be shown that a very thin single-printed seed layer leads to the best contact properties.