Fraunhofer-Gesellschaft

Publica

Hier finden Sie wissenschaftliche Publikationen aus den Fraunhofer-Instituten.

Encapsulant characterization - valuable tools for process setup and failure analysis

 
: Becker, K.F.; Braun, T.; Koch, M.; Vogel, D.; Aschenbrenner, R.; Reichl, H.; Hagedorn, H.W.; Neumann Rodekirch, J.

:

2nd International IEEE Conference on Polymers and Adhesives in Microelectronics and Photonics, POLYTRONIC 2002. Conference proceedings : June 23 - 26, 2002, Hotel Balaton, Zalaegerszeg, Hungary
Piscataway, NJ: IEEE, 2002
ISBN: 0-7803-7567-X
S.96-103
International Conference on Polymers and Adhesives in Microelectronics and Photonics (Polytronic) <2, 2002, Zalaegerszeg>
Englisch
Konferenzbeitrag
Fraunhofer IZM ()
encapsulant characterization; process setup analysis; failure analysis; optimum material; underfill encapsulant; material parameter; package reliability; test method; processable encapsulant; flip chip assembly; integrated inspection; CTE; Young's modulus; adhesion; flow modul; empirical test vehicle; underfiller flow; nondestructive testing; destructive testing; DSC; dynamic mechanical analysis; glass transition temperature; acoustic microscopy; contact resistance

Abstract
The selection of the optimum material for an encapsulation application can be a challenging task, as typically the datasheets do only provide general information, e.g. CTE below glass transition temperature or Young's modulus at room temperature. The reason is that a full material characterization is rather sumptuous, due to the wide variety of material parameters possibly relevant. There are parameters for process setup and evaluation as rheological behavior and reaction behavior and there are application specific parameters as e.g. thermal conductivity, degradation temperature or media resistance. Therefore the determination and definition of relevant methods and parameters are important as results must be comparable. This is especially true as sample preparation and testing is time and cost intensive. Within the BMBF- sponsored project PUMA, a test schedule was set up to fully characterize various underfill encapsulants and to check relevance of material parameters for process development and package reliability. In summary this paper proposes test methods suited for encapsulant characterization, so material measuring techniques can be homogenized, results are comparable and material selection is facilitated.

: http://publica.fraunhofer.de/dokumente/N-16809.html