Fraunhofer-Gesellschaft

Publica

Hier finden Sie wissenschaftliche Publikationen aus den Fraunhofer-Instituten.

Effects of grain size and humidity on fretting wear in fine-grained alumina, Al2O3/TiC, and zirconia

Einflüsse von Korngröße und Feuchtigkeit auf den oszillierenden Reibverschleiß von feinkörnigem Sinterkorund, Al2O3/TiC-Kompositen und Zirkoniumoxid
 
: Krell, A.; Klaffke, D.

:

Journal of the American Ceramic Society 79 (1996), No.5, pp.1139-1146
ISSN: 0002-7820
English
Journal Article
Fraunhofer IKTS ()
alumina; composite ceramics; friction; Gefügeeinfluß; hardness; Härte; Komposit-Keramik; microstructure examination; Reibung; Sinterkorund; Verschleiß; wear; zirconia; ZrO2-Keramik

Abstract
Friction and wear of sintered alumina with grain sizes between 0.4 and 3 my were measured comparing with Al2O3/TiC composites and with tetragonal ZrO2(3 mol-% Y2O3). The dependence on the grain boundary toughness and residual microstresses is investigated, and a hierarchical order of influencing parameters is observed. In air, reduced alumina grain sizes improve the micromechanical stability of the grain boundaries and the hardness, and reduced wear is governed by microplastic deformation with few pull-out events. Humidity and water slightly reduce the friction of all of the investigated ceramics. In water, this effect reduces the wear of coarser alumina microstructures. The wear of aluminas and of the Al2O3/TiC composite is similar, it is lower than observed in zirconia where extended surface cracking occurs at grain sizes as small as 0.3 my.

: http://publica.fraunhofer.de/documents/PX-10668.html