Hier finden Sie wissenschaftliche Publikationen aus den Fraunhofer-Instituten.

Tribological Investigations on Tool Surfaces for Temperature-Supported Forming of Magnesium AZ31 Sheets

: Caetano dos Santos Silva, Bruno; Mendes Rodrigues, Alisson; Müller, Roland; Lora, Fábio André; Luis Ferreira Nascimento, Marcio; Cavalcanti Pinto, Haroldo; Santiago Coelho, Rodrigo

Fulltext ()

Materials 13 (2020), No.11, Art. 2465, 14 pp.
ISSN: 1996-1944
Journal Article, Electronic Publication
Fraunhofer IWU ()
forming process; tool design; magnesium alloy AZ31; periodic surface structures; friction coefficient

Aiming to decrease friction coefficient (µ) during the forming of magnesium alloy sheets, nine (9) tools with different hole geometries in their surface (flat, elliptical, and circular) were manufactured from steel Boehler W400 VMR (as known as DIN 1.2343). Tribological investigations were accomplished on a strip drawing machine at 288 °C without lubricants. When compared with a standard tool (surface flat), on average, tools with circular geometries in their surface showed the smallest friction coefficient, while tools with elliptical geometries shown higher. The friction coefficient also was confronted with the ratio between area occupied by holes in the surface of the tool and the total tool surface (i.e., factor f (%)), hole diameter (Ø), and the distance between circle centers (d(c,c)). Principal Component Analysis (PCA) complemented the experimental approach. In summary, both approaches (experimental and theoretical) indicated that the manufactured tool with circular geometries on its surface presented lower friction coefficient values on the forming processes of the magnesium AZ31 sheets.