Fraunhofer-Gesellschaft

Publica

Hier finden Sie wissenschaftliche Publikationen aus den Fraunhofer-Instituten.

Effect of scandium content on structure and piezoelectric properties of AlScN films deposited by reactive pulse magnetron sputtering

 
: Zywitzki, Olaf; Modes, Thomas; Barth, Stephan; Bartzsch, Hagen; Frach, Peter

:

Surface and coatings technology 309 (2017), pp.417-422
ISSN: 0257-8972
English
Journal Article
Fraunhofer FEP ()
aluminum scandium nitride films; pulse magnetron sputtering; structure; piezoelectric properties; Young's modulus

Abstract
AlxSc1 − xN films were deposited by reactive pulse magnetron co-sputtering from aluminum and scandium targets without additional substrate heating at deposition rates between 100 and 150 nm/min. With increasing in corporation of scandium into the hexagonal wurtzite structure, the piezoelectric properties are drastically improved. The piezoelectric charge coefficient d33 is increased from 8.4 pC/N for AlN up to 23.6 pC/N forAlxSc1 − xN with 33% scandium. Between 35 and 43% scandium content a relative broad maximum with high piezoelectric coefficients between 26.9 and 27.3 pC/N was detected. A further increase of scandium concentration above 50% results in the formation of the cubic and centro symmetric rock salt structure and therefore the complete loss of piezoelectric properties. By FE-SEM, XRD and TEM investigations it was shown that up to up to 43% scandium concentration the wurtzite structure becomes more and more disordered and the c/a ratio is decreased from 1.6 to 1.27. Nevertheless, no aluminum or scandium segregation could be detected by high resolution TEM investigations. The Young's modulus of the wurtzite phase is reduced with increasing scandium concentration from 340 GPa to 185 GPa. The drastic improvement of the piezoelectric properties can be explained by weakening of the chemical bonding and by high distortion of the wurtzite structure.

: http://publica.fraunhofer.de/documents/N-429061.html