Fraunhofer-Gesellschaft

Publica

Hier finden Sie wissenschaftliche Publikationen aus den Fraunhofer-Instituten.

CrCu based UBM (under bump metallization) study with electroplated Pb/63Sn solder bumps - interfacial reaction and bump shear strength

 
: Jang, S.Y.; Wolf, J.; Ehrmann, O.; Gloor, H.; Schreiber, T.; Reichl, H.; Paik, K.W.

:

IEEE transactions on components and packaging technologies 26 (2003), No.1, pp.245-254
ISSN: 1521-3331
English
Journal Article
Fraunhofer IZM ()

Abstract
The electroplating solder bumping process offers fine pitch, high reliability, and cost effective advantages for flip-chip technology. In this technology, under bump metallization (UBM) is required for chemical solder deposition and mechanically reliable solder contact to Al pads. An evaporated Cr/phased CrCu/Cu structure UBM has been used with 95Pb/5Sn and also with 37Pb/63Sn solder for flip-chip interconnection. In this study, the intermediate CrCu layer is modified using various sputtering techniques, and the underlying Cr adhesion layer is compared with TiW. Six UBM systems were selected, and their interfacial reaction and bump shear strength were investigated using 100 /spl mu/m and 50 /spl mu/m size electroplated Pb/63Sn solder bumps. The results demonstrate that the final Cu layer should have a minimum thickness, more than 0.8 /spl mu/m, for interface stability on CrCu based UBMs. Intermetallic compound growth and CrCu layer interface changes are more severe after 20 min reflow at 210/spl deg/C compared with 1000 h aging at 125/spl deg/C. Especially for small size bumps, a more stable interface between UBM and solder bump is required.

: http://publica.fraunhofer.de/documents/N-38280.html