Fraunhofer-Gesellschaft

Publica

Hier finden Sie wissenschaftliche Publikationen aus den Fraunhofer-Instituten.

Influences on the part quality in conventional deep drawing processes

 
: Behrens, B.; Yun, J.; Schäffner, C.; Sundkötter, C.; Kröning, M.; Altpeter, I.; Kopp, M.

Hagen, I. von:
Steel - Future for the Automotive Industry : Proceedings Steels in Cars and Trucks 2005. Wiesbaden, June 05-10, 2005
Düsseldorf: Verlag Stahleisen, 2005
ISBN: 3-514-00718-7
pp.144-151
International Conference on Steels in Cars and Trucks (SCT) <2005, Wiesbaden>
English
Conference Paper
Fraunhofer IZFP ()
sheet metal forming; spring back; residual stress; 3MA sensor

Abstract
Trends in the automotive industry tend towards safety, fuel saving and reduction of emissions. This leads to an increased application of higher-and high strength steels in car body production. One problem when cold forming these steels is spring back. This paper will discuss the effects of relevant forming parameters on spring back. In order to visualize the influence of forming parameters on sheet metal parts Barkhausen noise, which is correlated with the residual stresses, was measured nondestructively by 3MA (Micromagnetic Multiparameter Microstructure- and Stress Analysis).

: http://publica.fraunhofer.de/documents/N-28903.html