Fraunhofer-Gesellschaft

Publica

Hier finden Sie wissenschaftliche Publikationen aus den Fraunhofer-Instituten.

Chip length effect on the wear of coated cemented carbide inserts in milling

 
: Bouzakis, K.-D.; Gerardis, S.; Katirtzoglou, G.; Makrimallakis, S.; Skordaris, G.; Efstathiou, K.

:

The coatings in manufacturing engineering. Selected, peer reviewed papers from the 8th International Conference on THE Coatings in Manufacturing Engineering 2010 : Erlangen-Germany, April 14-15, 2010
Stafa-Zurich: Trans Tech Publications, 2010 (Key engineering materials 438)
ISBN: 978-0-87849-272-5
ISBN: 0-87849-272-0
pp.49-56
International Conference THE Coatings in Manufacturing Engineering <8, 2010, Erlangen>
English
Conference Paper
Fraunhofer IPT ()

Abstract
The effect of the developed chip length on the coated tool's cutting performance was investigated. Milling experiments at various cutting speeds and chip lengths were performed, which resulted to different tool wear developments. To explain these results, a FEM simulation of the cutting process was conducted and the related chip geometries were predicted and compared to the corresponding experimental ones. Based on these results, the Coulomb friction coefficient between chip and tool rake was appropriately adjusted to achieve a sufficient correlation between experimental and computational data. By additional FEM calculations, the mechanical and thermal loads of the cutting edge were estimated and insight was provided concerning the effect of chip length on coated tool stresses and film fatigue fracture. The obtained results revealed that the chip length reduction improves the cutting performance of coated tools and a significant increase of the removed material volume a nd material removal rate as well can be achieved.

: http://publica.fraunhofer.de/documents/N-171879.html