Hier finden Sie wissenschaftliche Publikationen aus den Fraunhofer-Instituten.

Effects of laser parameters on the mechanical response of laser irradiated micro-joints

: Mian, A.; Mahmood, T.; Auner, G.; Witte, R.; Herfurth, H.; Newaz, G.

Materials Research Society -MRS-:
Electrobiological interfaces on soft substrates : April 17 - 21, 2006, San Francisco, California, USA
Warrendale, Pa.: MRS, 2006 (Materials Research Society Symposium Proceedings 926)
ISBN: 1-558-99883-7
ISBN: 978-1-558-99883-4
ISSN: 0272-9172
Symposium "Electrobiological Interfaces on Soft Substrates" <2006, San Francisco/Calif.>
Materials Research Society (Spring Meeting) <2006, San Francisco/Calif.>
Conference Paper
Fraunhofer ILT ()

This paper is devoted to the laser irradiated joints between glass and polyimide. To facilitate bonding between them, a thin titanium film with a thickness of approximately 0.2 m was deposited on glass wafers using the physical vapor deposition (PVD) process. Two sets of samples were fabricated where the bonds were created using diode and fiber lasers. The samples were subjected to tension using a microtester for bond strength measurements. The failure strengths of the bonds generated using fiber laser are quite consistent, while a wide variation of failure strengths are observed for the bonds generated with diode laser. Few untested samples were sectioned and the microstructures near the bond areas were studied using an optical microscope. The images revealed the presence of a sharp crack in the glass substrate near the bond generated with the diode laser. However, no such crack was observed in the samples made using fiber laser. To investigate further the reasons behi nd such discrepancy in bond quality, three-dimensional uncoupled finite element analysis (FEA) was conducted for both types of samples. The transient heat diffusion-based FEA model utilizes the laser power intensity distribution as a time dependent heat source to calculate the temperature distribution within the substrates as a function of time.