Fraunhofer-Gesellschaft

Publica

Hier finden Sie wissenschaftliche Publikationen aus den Fraunhofer-Instituten.

Determination of the dill parameters of thick positive resist for use in modeling applications

 
: Roeder, G.; Liu, S.; Aygun, G.; Evanschitzky, P.; Erdmann, A.; Schellenberger, M.; Pfitzner, L.

:

Tompkins, H.G.:
5th International Conference on Spectroscopic Ellipsometry, ICSE 2010 : Held in Albany NY, USA from May 23 to May 29, 2010
Amsterdam: Elsevier, 2011 (Thin solid films 519.2011, Nr.9)
ISSN: 0040-6090
pp.2978-2984
International Conference on Spectroscopic Ellipsometry (ICSE) <5, 2010, Albany/NY>
English
Conference Paper, Journal Article
Fraunhofer IISB ()

Abstract
The determination of Dill parameters of thick resist is very important to improve simulation models of resist exposure and real world processes. A new extraction technique of Dill parameters based on spectroscopic ellipsometry in combination with an advanced resist exposure model is proposed for thick resist analysis. The complex refractive index of the resist is related to the relative concentration of the photoactive compound in the resist in order to describe the vertical distribution of the refractive index and the extinction coefficient. Moreover, Dill parameters are extracted by directly fitting the bleaching curves to the measured ellipsometry data. The new approach was investigated experimentally by spectroscopic ellipsometry measurements on AZ5214E resist with two moderate layer thickness values in order to verify the accuracy of the new method. Dill parameters were extracted by using this new technique and by applying resist samples subjected to different exposure doses. Possible reasons for the variation of Dill parameters depending on resist thickness are explained. Furthermore, advantages, limitations and potential improvements of the model are discussed. Finally, the impact of Dill parameter variation on image formation in the resist is demonstrated by applying the spectroscopic ellipsometer analysis results as input parameters to the lithography simulator Dr.LiTHO.

: http://publica.fraunhofer.de/documents/N-163334.html