Fraunhofer-Gesellschaft

Publica

Hier finden Sie wissenschaftliche Publikationen aus den Fraunhofer-Instituten.

Aluminum-rich TiAlCN coatings by low pressure CVD

 
: Endler, I.; Höhn, M.; Herrmann, M.; Holzschuh, H.; Pitonak, R.; Ruppi, S.; Berg, H. van den; Westphal, H.; Wilde, L.

:

Surface and coatings technology 205 (2010), No.5, pp.1307-1312
ISSN: 0257-8972
International Conference on Metallurgical Coatings and Thin Films (ICMCTF) <37, 2010, San Diego/Calif.>
English
Journal Article, Conference Paper
Fraunhofer IKTS ()
TiAlCN; hard coating; CVD; wear

Abstract
Ti1 - xAlxN is a well established material for cutting tool applications exhibiting a high hardness and an excellent oxidation resistance. A main route for increasing the performance of Ti1 - xAlxN is the incorporation of further elements. Therefore the main objective of this work is to improve the properties and wear resistance of aluminum-rich CVD–TiAlN coatings by incorporating carbon. A new Low Pressure CVD process was employed for the deposition of a very aluminum-rich TiAlCN layers. The process works with a gas mixture of TiCl4, AlCl3, NH3, H2, N2, Ar and ethylene as carbon source. In this work microstructure, composition, properties and cutting performance of CVD–TiAlCN coatings were investigated.
Hard aluminum-rich TiAlCN coatings were obtained at 800 °C and 850 °C consisting of a composite of fcc-Ti1 - xAlxN and minor phases of TiN, h-AlN and amorphous carbon. WDX analysis indicates only a low carbon content < 2 at.%. Lattice constant calculations suggest that carbon atoms should not be incorporated in the Ti1 - xAlxN lattice. From TEM analysis and Raman spectroscopy it is evident that carbon is mainly located at the grain boundaries as a-C phase. Therefore these fcc-Ti1 - xAlxN(C) coatings with low carbon content are rather a composite of fcc-Ti1 - xAlxN and an amorphous carbon phase (a-C). At 900 °C the metastable fcc-Ti1 - xAlxN nearly disappears and co-deposition of TiN and h-AlN occurs. The layers deposited at 800 °C and 850 °C possess a high hardness around 3000 HV and compressive stress. CVD–TiAlCN coatings prepared at 850 °C shows also an amazing thermal stability under high vacuum conditions up to 1200 °C. Aluminum-rich composites fcc-Ti1 - xAlxN/a-C with x > 0.8 exhibit a superior cutting performance in different milling tests.

: http://publica.fraunhofer.de/documents/N-145717.html