
Publica
Hier finden Sie wissenschaftliche Publikationen aus den Fraunhofer-Instituten. Enlargement of the application range of solid punch riveting by two-piece dies
:
Fulltext urn:nbn:de:0011-n-1288819 (512 KByte PDF) MD5 Fingerprint: 16531e1a008686a609de5745bd53704f Created on: 1.4.2011 |
| Univ. of Bergamo, Department of Design and Technologies; European Scientific Association for Material Forming: 13th International ESAFORM Conference on Material Forming 2010. Book of Abstracts : April 7-9, 2010, Brescia, Italy Brescia, 2010 4 pp. |
| International Conference on Material Forming <13, 2010, Brescia> |
|
| English |
| Conference Paper, Electronic Publication |
| Fraunhofer IWU () |
| solid punch riveting; joining by forming; two-piece dies; die improvement |
Abstract
Punch riveting with solid rivets is an admitted technology in joining by forming of metallic workpieces. Conventional this technology works with a rigid die. This causes the disadvantage of dimensioning the width of the coining contour separately for every single joining task to avoid a prematurely coining during the blanking stage. By using a two-piece die an improvement is feasible. Thus there can be realized a plane surface of coining ring and die ring during the stamping process. So an equal coining ring can be used for all joining tasks. The article shows the advantages of the two-piece dies especially in joining of different materials with distinct differences in strength. The use of these dies effects convenient technological conditions and an extended range of application for solid punch riveting.