PublicaHier finden Sie wissenschaftliche Publikationen aus den Fraunhofer-Instituten.
Mechanical joining of magnesium alloys with a heated anvil as counter tool
Mechanisches Fügen von Magnesiumwerkstoffen mit beheiztem Amboss als Gegenwerkzeug
urn:nbn:de:0011-n-1108959 (666 KByte PDF)
MD5 Fingerprint: 935946a9b5500eff713224712302c308
Copyright 2010 ahrefhttp://www.interscience.wiley.com/Wiley-VCH/a
Created on: 31.3.2011
Clinching is a technology for joining component parts from the same or different materials and it is also a low-cost technique that has proved its worth many times over in industry. The prerequisite for using clinching technology is sufficient material forming properties since component parts are substantially deformed around the joining point. Unfortunately, the formability of magnesium alloys at room temperature is low, which is why cracks might form in component parts with clinching. However, its formability improves significantly if this material is heated to temperatures in excess of 220° C. This is the reason why crack-free clinch joints can only be made by heating component parts to 220° C. Heating also requires more time, which impairs this technique's economic efficiency. This paper will present the two new clinching techniques of dieless clinching and dieless rivet clinching. The dieless clinching technique is excellent for joining magnesium materials in comparison toconventional clinching techniques. While local component heating takes at least 3-6 seconds with conventional clinching. Dieless clinching needs less than 1 second for heating. This paper explains and describes these techniques and their benefits specifically for joining magnesium materials. It will not only explicate parameter studies on the im-pact of tool or rivet geometries, but also the combination of dieless clinching and adhesive bonding.